publicationethics.org

Experimental study on the settings of Delta and Cartesian 3D printers for samples printing

10.15660/AUOFMTE.2021-2.3593

M Ratiu, D M Anton, D C Negrau

mratiu@uoradea.ro

Volume XXX, 2021/2

This paper presents the first part of the experimental procedures developed at the beginning of a larger research, consisting of printing, on two 3D printers, one parallel and one cartesian, of some test specimens, in different working conditions and with different settings of some parameters, and then investigation of the tensile and compressive behavior of the test specimens. The research was carried out on two sets of standardized samples, printed with three types of the commonly used and low-cost material, Polylactic acid (PLA), Carbon fiber PLA (CF-PLA), and Polyethylene terephthalate glycol (PETG).

ISSN 1583-0691, CNCSIS "Clasa B+"